// Status=review
.Transmitting

Immediately before the start of a transmission _WSJT-X_ encodes a
user's message and computes the sequence of tones to be sent.  The
audio waveform is computed on-the-fly, sending 16-bit integer samples
to the audio output device at a 48000 Hz rate.  Generated JT65 and JT9
signals have continuous phase and constant amplitude, and there are no
key clicks.  The transmitter's power amplifier need not be highly
linear.


.Receiving

_WSJT-X_ acquires 16-bit integer samples from the audio input device
at a 48000 Hz rate and immediately downsamples the stream to 12000 Hz.
Spectra from overlapping segments are computed for the waterfall
display and saved at intervals of 0.188 s, half the JT9 symbol length.

.Decoding

At the end of a reception sequence, about 50 seconds into the UTC
minute, received data samples are forwarded to the decoder.  For
operator convenience the decoder goes through its full procedure
twice: first at the selected Rx frequency, and then over the full
displayed frequency range.  Each decoding pass can be described as a
sequence of discrete blocks.  The functional blocks are different
for the JT65 and JT9 modes.

The basic decoding algorithm for JT65 mode is described in the 2005
{jt65protocol} paper.  The following list summarizes the corresponding
algorithm for JT9 mode. Blocks are labeled here with the names of
functional procedures in the code.

[horizontal]
+sync9+::    Use sync symbols to find candidate JT9 signals 
            in the specified frequency range

Then, at the frequency of each plausible candidate:

[horizontal]
+downsam9+::  Mix, filter and downsample to 16 complex 
            samples/symbol

+peakdt9+::   Using sync symbols, time-align to start of JT9 symbol 
            sequence

+afc9+::    Measure frequency offset and possible drift

+twkfreq+::   Remove frequency offset and drift

+symspec2+::  Compute 8-bin spectra for 69 information-carrying
            symbols, using the time- and frequency-aligned data;
            transform to yield 206 single-bit soft symbols

+interleave9+:: Remove single-bit interleaving imposed at the
	    transmitter

+decode9+::   Retrieve a 72-bit user message using the sequential
            Fano algorithm 


+unpackmsg+:: Unpack a human-readable message from the 72-bit 
            compressed format

Decoding of clean JT9 signals in a white-noise background starts to
fail below signal-to-noise ratio -25 dB and reaches 50% copy at -26
dB.

With marginal or unrecognizable signals the sequential Fano algorithm
can take exponentially long times.  If the +sync9+ step in the above
sequence finds many seemingly worthy candidate signals and many of
them turn out to be undecodable, the decoding loop can take an
inconveniently long time.  For this reason the step labeled +decode9+
is programmed to ``time out'' and report failure if it is taking too
long.  The choices *Fast | Normal | Deepest* on the *Decode* menu
provide the user with a three-step adjustment of this timeout limit.
